Our Expertise & Consulting service is at your disposal to carry out simulation studies when you are solicited following a call for tender or when facing specific manufacturing issues. This service brings you many benefits to improve the development process of your products.
Whether your needs are punctual or recurrent, our Expertise & Consulting department carries out your simulations and then provides you with a detailed analysis of the results.
We are ready to assist you in the design of your manufacturing sequences by validating your tool or mold designs, studying alternative solutions to optimize the process stages and contributing to the reduction of material used.
Rent computation time on our HPC servers in order to answer more quickly to your customer requests, assuming that your own shared computing means are temporarily overloaded with large batches of simulations.
Based on 30 years of experience and software knowledge, we provide our expertise for the realization of your tailor-made simulations.
Our teams are constituted of engineers specialized in numerical simulation of material forming and many of them also have previous professional experiences in the industry.
During this study, our team was able to verify the impact of the forging sequence on multiple factors, including residual stresses. It was able to analyze, according to Dang Van criterion, the fatigue strength of the component subjected to a load similar to normal conditions of use.
Take advantage of our computing power to carry out your parametric studies, in order to determine the sizing of new equipment or even to optimize an existing process.
This study made it possible to validate the optimal casting conditions, in order to minimize the appearance of cracks and hot tears on large steel parts.
Our team brought their expertise to study the conditions of implementation of PUR foam by chemical foaming, in order to optimize the thermal insulation properties for general public water heaters.
‘The models developed during this study using advanced FORGE® functionalities or modules under development, the support of Transvalor were essential to be get results.’
‘The results are in line with our expectations, they clearly show the influence of a few key parameters on the products quality obtained. The developed models will therefore be applied for the optimization of the cold forming process, thanks to the training provided for their use.’
‘Very good level of work, up to our expectations for this exploratory phase. Constructive discussions with the project manager.’